Third party software and hardware support forums. > PoKeys

pokeys and G100 question

(1/1)

bramvh:
H,

I have currently a G100 set up to control my cnc, and that works just fine, but now I want to build a toolchanger that requires more io than available on the Grex.
I saw on the docs that pokey uses the same addresses as the G100. so now my question: can G100 and pokeys55 be used at the same time for digital outputs in mach? or is that going to mess up the system?

thanks,
Bram

borisz:
Does not have direct answer.
If Mach and G100 plugins will mess up, you can command PoKeys directly with PoKeys.dll

regards

Boris

bramvh:
hi,

thanks for your reply, i would need the pokeys mainly for outputs, is that also possible with the dll ? how do i tell mach to use that dll? or is the dll only for simulating the keystrokes?

regards,
Bram

borisz:
Please download and read PoKeys user manual from www.poscope.com
There is all described here.
Dll can be used for all PoKeys functions inputs and outputs.

regards

Boris

Navigation

[0] Message Index