My lathe has it's X axis home/ limit switch at the end of the axis' travel. The Z axis one is somewhere in the middle of it's travel. My problem is, when I go to set home with both, the Z axis will go there, then reverse off and stop, with no problems. The X axis however, when it goes there, then reverses, I get a limit switch triggered error, and I can't jog or go anywhere anymore. I have used a workaround in tabbing to the jog flyout screen, then switching off the limits override button, then jogging off, then switching the limits override back on again, but it shouldn't be like this. Any ideas?