Hello Guest it is August 08, 2020, 09:34:12 AM

Author Topic: Old MaxNC Controller open Loop two Port  (Read 2838 times)

0 Members and 1 Guest are viewing this topic.

Old MaxNC Controller open Loop two Port
« on: July 27, 2006, 11:51:56 AM »
Hello veryone my name is Milt., I have question:
I have an old max nc controller, that I want to put use. It uses two  port Parallel ports. X,Y at address 278, and A,Z at address  378.
My question is ,what Mach product do I use, and how do I set it up?
Re: Old MaxNC Controller open Loop two Port
« Reply #1 on: July 27, 2006, 02:15:39 PM »
Im going to be totally honest with you on this.....
I too had a MAXNC older OL copntroller.   It developed some minor issues.   Finally got ahold of someone at MAXNC.......   they wanted to sell me a whole new controller.    Said that I could send in my box,  they would look at it for $55 an hour.  Most things take 3 to 4 hours to fix plus parts.... Or I could get a new controller  (2005) model for $375.......

The run around I got with them.........   ICK.....
So I ordered a new 4 axis xylotek controller.

But to answer half your question.......
I know Mach 2 should work for what your neededing,  and I beleive Mach 3 will as well.

as for the setup.......  Dunno as I have NIXED Maxnc