Hello Guest it is March 28, 2024, 04:17:13 PM

Author Topic: Modifiying top file bar  (Read 5885 times)

0 Members and 1 Guest are viewing this topic.

Modifiying top file bar
« on: January 28, 2009, 01:55:39 PM »
I apologize if this has been covered. Is it possible to remove the top file bar so that only the control screen is visible and put the top bar in a limited location for access? I don't want my operators to have access to any system functions.
 Thanks,
  Richard Konnen

Offline budman68

*
  • *
  •  2,352 2,352
    • View Profile
Re: Modifiying top file bar
« Reply #1 on: January 28, 2009, 02:41:39 PM »
I believe this was discussed over at the Yahoo forum so do a search over there for it.

I'd be guessing it was about 3-5 months ago,

http://groups.yahoo.com/group/mach1mach2cnc/

Dave
----------------------------------------------------------------------
Just because I'm a Global Moderator, don't assume that I know anything !

Dave->    ;)

Offline poppabear

*
  • *
  •  2,235 2,235
  • Briceville, TN, USA
    • View Profile
Re: Modifiying top file bar
« Reply #2 on: January 28, 2009, 05:49:38 PM »
there are OEM button codes that diable the top bar, and another to re enable it, look in the wiki.

Also, you can use a resource editor to remove stuff from the bar (Tormach does this), but, each time you install or reinstall you will have to go and redo the resource editor.

Or there is a Plug in..........

scott
fun times
Re: Modifiying top file bar
« Reply #3 on: January 29, 2009, 06:59:44 AM »
Scott,
 Thanks, I hadn't read all the way to the end of the OEM list. Just what I was looking for. Also found a resource editor and was able to play with some settings also.
 Thanks again,
  Richard Konnen
Re: Modifiying top file bar
« Reply #4 on: January 29, 2009, 02:51:18 PM »
Now I have another question. I found the OEM buttons to turn the top bar off. Is there a way to have the bar off at boot up?
Thanks,
  Richard

Offline ger21

*
  • *
  •  6,295 6,295
    • View Profile
    • The CNC Woodworker
Re: Modifiying top file bar
« Reply #5 on: January 29, 2009, 05:43:19 PM »
There's a check box in general config.
Gerry

2010 Screenset
http://www.thecncwoodworker.com/2010.html

JointCAM Dovetail and Box Joint software
http://www.g-forcecnc.com/jointcam.html
Re: Modifiying top file bar
« Reply #6 on: January 29, 2009, 07:46:30 PM »
Gerry,
  Perfect, thanks. I have been using this program for 2 years and have yet to play with all the functions.
Thanks,
  again,
  Richard