Hello Guest it is October 21, 2020, 11:07:44 PM

Author Topic: mesanet anything i/o HostMot2 usb 2 parallel in Mach3 ?  (Read 2250 times)

0 Members and 1 Guest are viewing this topic.

mesanet anything i/o HostMot2 usb 2 parallel in Mach3 ?
« on: March 11, 2009, 04:51:07 AM »
Hi,
It seems that on linux it's supported a more cost effective board :

http://wiki.linuxcnc.org/cgi-bin/emcinfo.pl?EMC2_Supported_Hardware

http://www.mesanet.com/

Does anybody has an ideea if it was any intention to implement a driver for this board in Mach3 ?

REgards,
Daniel