Brian I made the change, closed Mach and they stayed in place. Then I changed the motor pins to get it referencing in the correct direction and that screw my jog directions up. Is there a chance that the referencing code is reversed?

Mike

You can change the Home Negative  state under the config/ Homing and Limits

Hope that helps
Brian

Thanks Brian......sometimes I get tunnel vision

Mike

Hi Brian, Art and or anyone else who might know.

I need to be able to manually override my persitant limit switches and can't. I finally found the check box on the settings page.....thinking all this time it was in the congif , but I cannot get a green led. This is all I need to be able to go ahead with the test. I may not actually since I not over the strep throat yet, but am getting there.

Mike