Third party software and hardware support forums. > LazyTurn
LAZYTURN MANUAL COMMENTS
RICH:
Hi all,
The LazyTurn Manual was updated and posted in Members Doc's.
Should be solid to about section 7.5, but past after that, need the program
to mature before working more on it. The appendixes are included it. No real
updates done to them as compared to the last posted revision of them.
Happy reading, and as usual, any remarks, corrections, whatever, just post in this thread
and i will make corrections.
RICH
DennisF:
Hey Guy's question when using a cam program are the post processer's the same for mill and turn i read to use a fanuc but for both lahe and mill ?
Dennis
RICH:
Not sure what you saying Dennis.
I would think that the CAM program , ie; Dolphin or what ever would have a postprocessor for MACH Mill and a seperate one for the lathe. In fact you may find there are two for the lathe,one for diameter mode and another for radius mode.I have used Fanuc to when trying some CAM programs and worked fine.
Now as far as Lazcam, it has it's owne postprocessor.
RICH
DennisF:
Hi Rich
I am looking into a couple of cam package's and i do see some of the post processor's on the mach list but there is only one for a given cam package so i was wondering would that one processor work for both application's thanks for the reply.
Dennis
Chip:
Hi, Dennis
If the CAM package offers Mill and Lathe, I'm thinking separate Post's for Mill and Lathe, It would be a stretch to think thy-ed be combined.
Chip
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version