Hello Guest it is May 09, 2025, 05:34:32 AM
Profile Guest
« previous next »
Pages: « 1 2   Go Down

Author Topic: Mach3 RnR motion card - problem with plasma relay  (Read 34339 times)

0 Members and 1 Guest are viewing this topic.

Offline Ken Rychlik

*
  • 4 4
Re: Mach3 RnR motion card - problem with plasma relay
« Reply #10 on: August 21, 2019, 05:13:12 PM »
Something like this board, but I needed more outputs.  Use the 24 volt version and it will work with the same power supply you use for the controller 24v input.  https://www.ebay.com/itm/5V-12V-24V-4-Channel-Optocoupler-High-Low-Trigger-Relay-Module-Board/183776948137?hash=item2ac9f5afa9:m:mPYQKyFRrlGUmBO9Hb0FcJg
Logged

Offline Cosmin-Jo

*
  • 1 1
Re: Mach3 RnR motion card - problem with plasma relay
« Reply #11 on: May 15, 2021, 06:28:37 PM »
works without problems, here are my settings ! I hope to help someone who uses 5 volt relay!  :) :)
Logged
Pages: « 1 2   Go Up
« previous next »