No, my goal is to cut in YX plane with IJ and G17. I have try with G90.1 and G91.1 with the diffrent values for IJ. This is only a simple example. I have the problem with all G3 Codes. The only G3 i have successful cut is a exact half circular.
I can not find the reason for the big difference between the red lines, thad comes up wen i load the program and the green line, thad is painting while the program runs.
If i run the full program, i get a full green circular for each G3 command.
Most of the program all three axes are move in minus area.