///////////////Configuration Check Facility///////////////////////
Any obvious errors are checked by this facility, passing does not mean
you have no errors, but as more error possibilities are found,
more checks will be added to this facility.
Currently, the most frequenct tech-support errors are checked for.
///////////////LIMIT & HOMING CHECK///////////////////////
Limit Switch found enabled, and activated.
A switch may be misset in its Active Low setting. No LED's on the
Diags page under Inputs should be lit up unless a switch is pressed
if one IS, then reverse the setting of the LowActive param for that
Switch in the config/ports&Pins/Input Signals tab.
////////////////////// End of Homing and Limits Check ///////////////////////////////////
///////////////OUTPUT Signals Check///////////////////////
Pin for an Output found as not pins 1 - 9, 14, 16, or 17. Unless using ModBus, this is wrong.
///////////////End of OUTPUT Signals Check///////////////////////
//////////////// Digitising Probe /////////////////////////
Digitising Probe Pin setting may be wrong
It should be pins 10-13 or 15. Check it before use!.
/////////End of Probe Check /////////////////////!.
/////////Motor Settings - Enabled Motors only are Checked/////////////////////!.
/////////Motor Settings - End of Motor Checks/////////////////////!.
Checkup complete , please check any errors listed.
Thank you for checking your Settings.....