For those looking for a decent Gcode Primer to add to their libarary check this out. It is the Haas Gcode programmer manual work book.  The Hass Gocdes are very close to Mach3. Just overlook the ones that Mach3 does not support. OR email Andrew to have them put in MACH3 (;-)

http://www.google.com/url?q=http://www.egr.unlv.edu/~kevinn/CNCworkbooks/MillProgrammingBook.pdf&sa=U&ei=hrjoTtipPISbtwe4nM3KCg&ved=0CCQQFjAF&usg=AFQjCNHvCT-zo5fQm5b-vthja5wdLDJfkg

Just a thought, (;-) TP

Thanks for posting, Terry, an interesting read for sure-

Thanks,
Dave

I feel obliged to point out that manual is copyrighted material....

HIYA RAY. THAT is why their is just a LINK to the manual and NOT the manual itself.  ANYONE can read the material and it was placed there to download.

ALL printed or recorded material is technically copywrited to the original authur.

IF you read the copywrite exclusion it says cannot be used FOR PROFIT without permission. (;-)

(;-) TP