motors not turning - please help (newbie)

Pages: « 1 2 3 4 Go Down

0 Members and 1 Guest are viewing this topic.

« Reply #30 on: June 11, 2011, 04:19:54 PM »

Thanks Hood. Where can I find the option? I don't see it in general Logic Config or Ports and Pins or Motor Tuning.

Tony

Logged

« Reply #31 on: June 11, 2011, 04:22:51 PM »

You using Mach3?
General Logic page is from Mach2 I think.
If using Mach3 then its on the main Ports and Pins page from Config menu.
Hood

Logged

« Reply #32 on: June 11, 2011, 04:24:36 PM »

Screenshot attached

Hood

ScreenHunter_02 Jun. 11 21.23.jpg (60.57 kB, 711x418 - viewed 553 times.)

Logged

« Reply #33 on: June 11, 2011, 04:29:30 PM »

Thanks Hood. I was staring right at it for twenty minutes and never saw it.

Tony

Logged

« Reply #34 on: June 11, 2011, 04:30:48 PM »

been there

Logged

Pages: « 1 2 3 4 Go Up