Hello Guest it is October 31, 2024, 08:00:15 PM
Profile Guest
« previous next »
Pages: 1   Go Down

Author Topic: Turn process won't accept profile  (Read 5811 times)

0 Members and 1 Guest are viewing this topic.

Offline kdoney

*
  • 78 78
Turn process won't accept profile
« on: September 25, 2009, 08:39:25 PM »
I can't get lazycam's turn process to accept a profile. I must be misunderstanding the basics. Can you get me started?
Logged

Offline RICH

*
  • *
  • 7,427 7,427
Re: Turn process won't accept profile
« Reply #1 on: September 25, 2009, 10:48:03 PM »
kdoney,
You should only draw the upper part of the profile in the dxf. Take a look at the manual, Tutorial #5 which covers lathe turning. I also have a few additional posts in the Members Docs which cover the lathe and suggest you take a look at them also.
RICH
Logged

Offline RICH

*
  • *
  • 7,427 7,427
Re: Turn process won't accept profile
« Reply #2 on: September 25, 2009, 10:57:33 PM »
My bad, as I deleted the other ones on the lathe in the members doc's, when i wrote the LazyCam Manual tutorial#5.
I would suggest you take a look at Appendix "B" in the LazyTurn Manual as that covers practical info on Cad drawings and common mistakes.
RICH
« Last Edit: September 25, 2009, 11:02:44 PM by RICH »
Logged

Offline kdoney

*
  • 78 78
Re: Turn process won't accept profile
« Reply #3 on: September 26, 2009, 11:46:44 AM »
I can't find any manual.
Logged

Offline RICH

*
  • *
  • 7,427 7,427
Re: Turn process won't accept profile
« Reply #4 on: September 26, 2009, 06:16:42 PM »
Look in the Members Docs:

RICH
Logged
Pages: 1   Go Up
« previous next »