Hi every body,
I think I found a Bug in Mach3, or maby I am just missusing the software.
I loaded a few g-codes using g02 and g03 in absolute mode, IJK coords.
Configured Mach in "IJ mode": Absolute .
I found than in every case Program limits show incorrect data and Display mode shows the part very far away from the home.
when programing the same parts without G02 and G03, evrithing works properly.
The most astonishing thing is that when I run the cicular interpolation program, the machine works as fine, producing a correct piece.
Does anybody has an idea of what may be wrong?