After a week or so of running my plasma table, i've realized a torch height control is going to be a necessity. Getting actual motion is no problem, however im wondering what would be ideal to control the motion. The plugin page lists a THC system from candcnc.com. But it looks like it only works with their BOB system. Im running the dsp Motion Controller, so that should make a difference with what i can run. Also the basis for my height control is a voltage feedback value from the plasma unit. Something like 50-300VDC. Which can easily be scaled for a 0-10V analog signal etc.
Does anyone know of any other solutions, is anyone else running a plasma with any other THC system?
Full Digital Torch Height Control Expansion Module
HUH? What's this? Because the DTHC is now a tiny plug-in module you can make ANY UBOB based product into a full blown Digital Torch Height Control. Comes with a matching THC Sensor Card for interface to your Plasma cutter.
NOTE: YOU CANNOT HAVE A ISS-O2 SPINDLE SPEED AND DTHC-Expansion Module plugged in at the same time.
Doesnt sound like it would work with my dsp motion contoller...