In the event the drives are not present I think I will use the drives from automation direct

http://www.sureservo.com/sva_2100.htm

While I'm planning on using some of these on a retrofit coming up soon, I think they may be small for your beast. Don't take my word for it though. AUD has a free download of servosizer. You can plug in all the variables and see if they will do what you need them to.

Brett

I think your right , the 2300 should be about right according to the calculator

machine is due to land here at the shop in 3 short hours, can hardly wait

Yeeeeeeeeeeeee Haaaaaaaaaaaaaaaaaaa!!!

Brett

2hp blower motor on the 30hp spindle motor




32 inches between tailstock and spindle, looks like hydraulic tailstock has 5" travel



here is the data sticker on the drive for the spindle motor. I need (hope) to run this machine at 230v , unsure if drive can be rewired or If I will need a new one




here are the insides of both the elec cabinets, no drives

That is one big DC motor.   At least the cabinets are very clean!

with the help of hood and chaoticone I got this machine all finished up . Runs like a top