Hello Guest it is October 31, 2024, 07:08:42 PM

Author Topic: Question regarding solid shapes!!  (Read 4059 times)

0 Members and 1 Guest are viewing this topic.

Question regarding solid shapes!!
« on: June 26, 2006, 06:26:09 PM »
HI,

I´m not sure if this is the right forum to post this I use AutoCad and I want to cut solid shapes for example I have a square 1/2 Inch thick wood and in the midle of that square I want to cut another square only 1/4  of an inch Thick in depth, how do I accomplish that in my drawing software say Autocad that will be recognised by Mach 2??

Thanks.

Roberto
Re: Question regarding solid shapes!!
« Reply #1 on: June 26, 2006, 07:14:53 PM »
You will need Cam software to read the 3D solids :(  LazyCAM will only take in a 2d file.... Google "Cam CNC" That should get you started :)
Fixing problems one post at a time ;)

www.newfangledsolutions.com
www.machsupport.com
Re: Question regarding solid shapes!!
« Reply #2 on: June 26, 2006, 07:19:39 PM »
What If I want to open holes for example just a round hole to put screws in ?? How can I set that on the machine?? Should I set like a small dot on the drawing for example??

Regards.

Roberto
Re: Question regarding solid shapes!!
« Reply #3 on: June 26, 2006, 07:33:14 PM »
Are you talking about teaching the machine the position? If so there is the teach wizard but it will not do points at this time :(

If you would like to do it with AutoCad you can save it as a 2D file and all points will be drilled
Fixing problems one post at a time ;)

www.newfangledsolutions.com
www.machsupport.com