Hi folks,
I have been using Mach4 build 4612 with ESS plugin 278.1 and so far.
I'm running a 3 axis gantry mill that is now engaged in producing precision non ferrous parts.
I learned the hard way about improper tool height practices
and the need of using a tool height sensor that bolts to the fixture plate. I Have so much to learn about that and will post a separate question.
Is there any benefit to updating to 5036 and the associated ESS plugin? Are there any features that would be useful or run smoother?
Warp9 recommends this and I have some time to do just that.
best regards,

Chris