Hello Guest it is May 17, 2025, 07:12:07 AM
Profile Guest
« previous next »
Pages: « 1 2   Go Down

Author Topic: Spindle runs on button double click but stops on M3  (Read 8662 times)

0 Members and 1 Guest are viewing this topic.

Offline ZASto

*
  • 428 428
Re: Spindle runs on button double click but stops on M3
« Reply #10 on: January 23, 2019, 05:25:19 PM »
You didnt have to modify the macro to wait for spindle to accelerate.
You can adjust the wait time in: Config/Ports & Pins/Spindle setup tab. There are CW Delay Spin UP, CCW Delay Spin Up ... parameters.
Kep your M3 macro simple.
Logged
Make no mistake between my personality and my attitude.
My personality is who I am.
My attitude depends on who you are.
Pages: « 1 2   Go Up
« previous next »