Hey all!

hoping someone can help me figure this out:

I recently installed Mach4 after having motor issues with a Pokeys controller and Mach3 (wouldn't slave the A-Axis with the Y-Axis).

Most everything during configuration went well, but I seem to be stuck with getting my y-axis home switch to be seen by Mach4.

I've used the Pokeys diagnostic routine, and it sees the activation of the Y home trip.  I can also see that Y-home activates, but never once do I see an event message as such.

I started logging and I do see an event of the Y Home, however, it seems like its missing an additional Signal id result, though that may just be me hoping for something easy.

i've tried to swap the X and Y home switches by changing the ports, and the problem stayed with the Mach Y-home and the physical switch in question worked fine as a X-Home.

needless to say, when I try to home the machine it just trips the limit switch and ignores the home.

Not sure what to try next...any thoughts?

Thanks


2025-02-10 18:44:29.918 [I    ] - Signal id 1000, (X ++), changed from LOW to HIGH.
2025-02-10 18:44:30.496 [I    ] - Signal id 97, (Motor 0 ++), changed from HIGH to LOW.
2025-02-10 18:44:30.496 [I    ] - Signal id 1000, (X ++), changed from HIGH to LOW.
2025-02-10 18:44:35.074 [I    ] - Signal id 65, (Motor 0 Home), changed from LOW to HIGH.
2025-02-10 18:44:35.074 [I    ] - Signal id 1002, (X Home), changed from LOW to HIGH.
2025-02-10 18:44:35.094 [I    ] - Signal id 65, (Motor 0 Home), changed from HIGH to LOW.
2025-02-10 18:44:35.094 [I    ] - Signal id 1002, (X Home), changed from HIGH to LOW.
2025-02-10 18:44:42.743 [I    ] - Signal id 98, (Motor 1 ++), changed from LOW to HIGH.
2025-02-10 18:44:42.743 [I    ] - Signal id 1003, (Y ++), changed from LOW to HIGH.
2025-02-10 18:44:43.031 [I    ] - Signal id 98, (Motor 1 ++), changed from HIGH to LOW.
2025-02-10 18:44:43.031 [I    ] - Signal id 1003, (Y ++), changed from HIGH to LOW.
2025-02-10 18:44:45.416 [I    ] - Signal id 66, (Motor 1 Home), changed from LOW to HIGH.
2025-02-10 18:44:45.782 [I    ] - Signal id 66, (Motor 1 Home), changed from HIGH to LOW.

I think your Y home switch is not properly mapped in the Input Signals settings. Double-check that Y Home is enabled and assigned to the correct input (Signal ID 66 or your Pokeys pin) in Configure -> Control -> Input Signals.