Hello everyone

I'm new to cnc and mach 3
I have a China 6040 with mkx4 mach3 motion card
Full version mach 3 on hp g56 windows 7
via   xhc mach 3 usbpod

When I jog y and z axis they move correct, on x axis I press left it moves right press right it moves left  both on keyboard and mpg
I opened config homing\limit  all axis had a X in reverse column  I then changed the X with a check thinking it would reverse x axis motor
Nothing changed same thing
I went back to homing limit and changed y and z axis to reverse to see if it was just x axis but nothing changed

I pressed OK to leave homing limit
Pressed save settings on cofig menu

Any ideas would be appreciated

Thanks
Signed
Stumped

In ports & pins where you setup the motor pins set the X axis only to active low, should go in the correct direction then when you use cursor keys.

Thank you for your help pcdoc, applied your solution and it works, thanks again