Hi Kenny
I agree will spare me lots of time but  had problem of double speed of slave axis when homing in mach . Is there any solution for  this problem at this moment
 btw I have very little experience with cnc  i am building may first mill witch is supposed to be finished in two months ,,,,,  if I can find solutions for gentry  and some more  
Firuz

Were both axes tuned the same in Mach?

Tuning parameter in mach                              master=slave
Servos and encoder type                                 master=slave
%sp homing                                                  master=slave
Motor tuning parameter in galil                        master=slave
Home slave with master axis                           uncheck
Perform axis squaring                                     check

After much discussion, I found that the slaved homing issue started with Mach3 a few releases back. I would suggest that you use an earlier release (sorry, don't knw which to recommend) until the issue is isolated and corrected. I wish that we could fix it in the plugin, but no joy at this time.
Kenny

I have read that you are one of authors of galilplugin and  understand that there  are many problems to take care about , hope you can isolate and solve this  problem .
 Until then I will try                - earlier plugins
                                           - geared axis  squaring done in galil  ( we will use mpg to test )
can you tell where to find earlier plugins  and there user pdf
Firuz

Its not an earlier plugin, but an earler version of Mach3 that you need to look for. That is what broke the gantry mode homing.
Kenny