Hello Guest it is May 01, 2025, 04:16:41 PM
Profile Guest
« previous next »
Pages: « 1 2   Go Down

Author Topic: direction signal from mach3  (Read 13451 times)

0 Members and 1 Guest are viewing this topic.

Offline Hood

*
  • 25,835 25,835
  • Carnoustie, Scotland
Re: direction signal from mach3
« Reply #10 on: April 12, 2009, 08:23:00 AM »
Afraid not, my knowledge of electronics is lower than zero.
Hood
Logged

Offline osman100

*
  • 36 36
Re: direction signal from mach3
« Reply #11 on: April 13, 2009, 07:17:26 AM »
dear hood
now my problem was solved there some friend from other site tell me this problem because the current is not enough to drive the load and the volt is 3.5 v at no load but at load it's drop to 1.5 so thy suggest to use switch circuit with transistor according to the following link http://ourworld.compuserve.com/homepages/Bill_Bowden/r_ctrl.htm
i used fig b with transistor 2n222a and now the relay is working probably good
all the best
Logged

Offline Hood

*
  • 25,835 25,835
  • Carnoustie, Scotland
Re: direction signal from mach3
« Reply #12 on: April 13, 2009, 07:51:46 AM »
Thats great and thanks for the link, I am sure it will come in handy :)
Hood
Logged
Pages: « 1 2   Go Up
« previous next »