One on one phone support.

If you require one on one phone support please post your request here, and you will be advised with an appointment time.

Pages: « 1 2 Go Down

	Subject / Started by	Replies / Views	Last post
0 Members and 4 Guests are viewing this board.
	plasma table project... Started by uuccimi	0 Replies 10,818 Views	August 14, 2008, 05:38:52 PM by uuccimi
	Please can i get some phone support Started by m4uk	5 Replies 5,976 Views	February 22, 2013, 01:28:28 PM by m4uk
	PM 940M CNC Mill Bought Second Hand without PC, Need help setting up Started by clayan	5 Replies 1,180 Views	January 22, 2023, 07:01:45 PM by Graham Waterworth
	ports and pins ....outputs .. random numbers filled in automatically Started by 1hander	0 Replies 2,891 Views	May 19, 2015, 03:06:19 PM by 1hander
	Random E-stops, urgent! Started by evilspeeder	3 Replies 4,385 Views	January 20, 2015, 03:07:57 PM by Chaoticone
	Request for phone support Started by JohnGonz	3 Replies 5,668 Views	July 02, 2018, 03:00:27 PM by JohnGonz
	request for phone support Started by ZanyGuy	0 Replies 3,825 Views	May 31, 2017, 11:16:36 AM by ZanyGuy
	request phone support Started by pjk	0 Replies 1,384 Views	August 23, 2020, 12:54:04 PM by pjk
	RESET not working Started by AJRERKO	3 Replies 10,165 Views	April 15, 2010, 12:47:49 PM by elpablito
	Sizing my parts Started by dbrenon	0 Replies 2,900 Views	June 21, 2017, 07:31:17 AM by dbrenon
	Softlimit bad behavior while massive probing Started by djmad	0 Replies 4,568 Views	May 23, 2016, 08:42:04 AM by djmad
	Spindle control on Plasma table Started by rrussell	0 Replies 5,415 Views	December 22, 2010, 06:48:55 PM by rrussell
	Stepper moves random directions, hits limit switch, stops Started by rBishop	0 Replies 21,561 Views	January 23, 2015, 11:17:53 AM by rBishop
	Tool offset dropped by wizards and G code. Z goes through material not to 0 Started by GMcG	2 Replies 3,628 Views	July 24, 2015, 10:46:47 AM by GMcG
	xml Started by PCH	2 Replies 4,400 Views	September 06, 2012, 11:23:33 AM by PCH
	xyz jog well but go crazy during run or return home Started by kafoowe	3 Replies 4,342 Views	June 30, 2014, 09:33:10 AM by kafoowe
	Y-axis not working, please call ASAP Started by conduit2012	0 Replies 3,664 Views	March 03, 2012, 07:30:08 PM by conduit2012
	Z-axis not working and would be happy with help Started by Pootao	2 Replies 4,765 Views	May 25, 2012, 09:38:47 PM by Pootao

Pages: « 1 2 Go Up

Normal Topic
Hot Topic (More than 15 replies)
Very Hot Topic (More than 25 replies)

Locked Topic
Sticky Topic
Poll