11
General Mach Discussion / Re: Taig Mill (using microproto 2000) need help to config mach software
« on: February 07, 2008, 02:59:27 PM »
Thanks for the advise. I'm sorry I believe I did down load mach 3 anyway I downloaded the newest one on the downloads locked version. I will check. I have the manual and at one time they had a very nice video tutorial but I can't find it anymore the ones on the support work with different areas such as the pump etc. I will check with taig and see if they have the xml that would make my life so much better and faster that's for the tip.
Mike
Mike