Hello Guest it is March 01, 2021, 12:55:17 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Saumur

Pages: « 1 2 3 4 5 6 7 8
71
LazyCam (Beta) / Re: LazyCam Pro question
« on: March 06, 2008, 09:50:38 AM »
so in other words at the moment LC is USELESS for lathe?

72
LazyCam (Beta) / Re: LazyCam Pro question
« on: March 05, 2008, 09:23:32 AM »
anyone can help me please?

73
LazyCam (Beta) / Re: LazyCam Pro question
« on: March 03, 2008, 09:59:10 AM »
Chip,

yes it a lathe program. Your drawing isn't correct.

Anyway i would like to know why when i create the g-code the tools settings i put don't change the code, it's like they don't get read.

Can you tell me how can i set up my tool?

thanks

74
LazyCam (Beta) / Re: LazyCam Pro question
« on: February 29, 2008, 12:03:17 PM »
I could do the g-code but i don't understand why when i put the tool it's like the program is not reading it.
In fact if i change the diameter of it the program will be the same.
Do i have to do something in Mach3 too?
Thanks

75
LazyCam (Beta) / Re: LazyCam Pro question
« on: February 29, 2008, 11:20:44 AM »
Guys, i'm sending you the dxf i'm using.
If you can tell me how i have to configure lazycam to generate a g-code of this i would really appreciate it since i can't do it...

Thanks

76
LazyCam (Beta) / Re: LazyCam Pro question
« on: February 21, 2008, 11:27:07 AM »
anyone?

77
LazyCam (Beta) / Re: LazyCam Pro question
« on: February 19, 2008, 10:07:06 AM »
can you work in diameter mode with lazycam?

thanks

78
LazyCam (Beta) / Re: LazyCam Pro question
« on: February 08, 2008, 10:02:41 AM »
Thanks.
Is there a way to put the measouring unit in mm? Because i work with mm but i can't find where i can change it.


79
LazyCam (Beta) / LazyCam Pro question
« on: February 06, 2008, 05:19:37 PM »
Hi guys.
With LazyCam i can import a drawing but then i don't know where i can set my tool's settings.
Can some1 explain me this?
Thanks

Pages: « 1 2 3 4 5 6 7 8