Hello Guest it is March 01, 2021, 01:00:55 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Saumur

Pages: « 1 2 3 4 5 6 7 8 »
51
General Mach Discussion / Re: Screen adjustment
« on: June 27, 2008, 06:54:10 PM »
thanks for your answer, can some1 confirm it?

thanks

52
General Mach Discussion / Screen adjustment
« on: June 26, 2008, 12:05:21 PM »
Hi guys,

when i load a g-code the screen with the toolpath shows up normally.
the problem is that if i zoom on it, after i edit the program the screen will unzoom and go back to normal position.
Is there a way to keep the toolpath zoomed as you prefere everytime?

thanks

53
General Mach Discussion / Backlash
« on: June 25, 2008, 11:40:37 AM »
Hi guys, i have a problem with backlash.
When i put the backlash on and i move for expample 1 mm, it moves to 1mm and then it does the backlash to correct.
As you know the backlash must be done BEFORE the 1mm movement.
Where can i configurate this function?

Thanks

54
Hi guys,

thanks for your answers even tought i don't understand what you are talking about.
As you can understand i'm a mach noob; the thing i wanted to know is if it's possible to do with wizard a conversational programation.
Since i have to do always the same drawing with difference values, i wanted to know if it's possible to make a program where you just change the values you need and then it will create a g code program. These values would be: thickness, radius, tool diameter, ecc...

Thanks for your answers

55
General Mach Discussion / Conversational programation of mach3 lathe
« on: April 30, 2008, 10:55:02 AM »
Is it possible to do a conversational programation with a mach3 lathe?

Thanks and best regards

56
LazyCam (Beta) / Re: LazyCam Pro question
« on: March 14, 2008, 12:21:21 PM »
Thanks for the answer,

yes that's a possibility i just wanted to know if you can create them in LC.

57
LazyCam (Beta) / Re: LazyCam Pro question
« on: March 14, 2008, 11:09:06 AM »
anyone knows?

58
LazyCam (Beta) / Re: LazyCam Pro question
« on: March 13, 2008, 11:10:48 AM »
Thanks for the help guys thanks to you i learnt many things.

If it's possible to do this i'll be able to do all the things i need: is it possible to create a g0 movement from lazycam so that when the piece is done the tool move away from it?
More like if with lazycam you can create a g0 movement you want or you must do it with your cad?

Thanks

59
LazyCam (Beta) / Re: LazyCam Pro question
« on: March 13, 2008, 10:45:39 AM »
THANK MAN!!!!

60
LazyCam (Beta) / Re: LazyCam Pro question
« on: March 12, 2008, 11:21:28 AM »
Thanks Chip,

one last thing; my drawing is divided in 4 chains.Is there a way to combine them all and have only 1 chain?
I tried with optimize and sometimes it combine 2 chains into 1 but after that i can't combine others 2.


Pages: « 1 2 3 4 5 6 7 8 »