Messages

11

General Mach Discussion / Re: Feed rate

« on: February 10, 2010, 09:45:45 AM »

Thanks, all clear

12

General Mach Discussion / Re: Feed rate

« on: February 10, 2010, 09:44:52 AM »

Thanks for your quick reply.

What I was wondering is if you can choose a feed rate used ALWAYS by putting it in the mach options, not the program.

Thanks

13

General Mach Discussion / Feed rate

« on: February 10, 2010, 09:20:21 AM »

Hey guys,

I was wondering where in mach3 Turn I can choose to put a feedrate I'm going to use in case the program doesn't refer to it.

Thanks!

14

General Mach Discussion / Re: Re-start the program from a different line

« on: January 29, 2010, 10:59:56 AM »

Thanks mate,

in the end we found the solution...

Thanks for being helpful as always.


C ya.

15

General Mach Discussion / Re: Re-start the program from a different line

« on: January 29, 2010, 10:32:19 AM »

I'm using the version R 2.63.

Just to make sure I'm using the From here option and then after pressing cycle that screen pops up.

16

General Mach Discussion / Re: Re-start the program from a different line

« on: January 29, 2010, 10:07:08 AM »

Hey Hood,

I'm attaching my xml.

Anyway just to let you know I'm doing these test from my comp not the actual machine.

Still they have the same program version and everything so it's strange.

thanks

17

General Mach Discussion / Re: Re-start the program from a different line

« on: January 29, 2010, 08:44:04 AM »

xml?

sorry I'm a noob.

18

General Mach Discussion / Re: Re-start the program from a different line

« on: January 28, 2010, 06:00:47 PM »

Hey man,

it's a turn profile, no doubt, I even cheked.

Seriously I have no words to describe what's going on...

19

General Mach Discussion / Re: Re-start the program from a different line

« on: January 28, 2010, 05:55:29 PM »

Hey guys,

no, I don't use the demo.
Also Hood my table is different from yours, instead of rapid dia mine says safe Z.... why???

Thanks....

20

General Mach Discussion / Re: Re-start the program from a different line

« on: January 28, 2010, 09:04:02 AM »

Hood thanks for helping.

I understand what you are tring to say but as I told you in the prep move box I can't type anything, only the safe Z which is useless in lathe.

You are telling me to put a different value in X so the Z moves 1st, but I can't!! The boxes are greyed out and I can't input any different value

Am I missing something??