1
General Mach Discussion / Fast Jog but it skips on G-Code
« on: February 05, 2008, 12:52:08 PM »
???I have my motor tuning set to 50 ipm and it runs fine with the jog controls. But when you run G-Code and the computer takes over, it skips steps on anything greater than 16 ipm. There basically is no load on my router. I'm just using a V-bit to carve in wood and only going 1/16" deep. What is even more strange is that when I change my motor tuning to anything less than 50 ipm it skips when you jog.
Is there any way to get a faster cut speed? I'd like to go up to at least 25 ipm. I'm using HobbyCNC kit that includes the driver board and motors.
Thanks,
Clint
Is there any way to get a faster cut speed? I'd like to go up to at least 25 ipm. I'm using HobbyCNC kit that includes the driver board and motors.
Thanks,
Clint