Messages

1

General Mach Discussion / Re: no go on 2nd port

« on: August 17, 2018, 09:42:20 PM »

We've tried 2 different PCI parallel port cards.

Rosewill RC-302 and Rosewill RC-303.

Neither one will run the A axis. Not sure what else to try.

2

General Mach Discussion / Re: no go on 2nd port

« on: August 12, 2018, 04:48:19 PM »

Have tried all the drivers I could find and none of them allowed me to change the settings on this card.

Is there a PCI card out there that people are using with good results?

Thanks ahead for the info.

3

General Mach Discussion / no go on 2nd port

« on: August 08, 2018, 12:48:21 PM »

i added a 2nd port for my 4th axis as far as i can tell mach is not recognizing it. the port checks out to be working but no go.the card address is  ecd8.  the card is rosewill rc-303. any help will be much appreciated!! i have been out of in cnc for about 8 years & have been working on getting this card working for about 6 days.
thanks greg

4

General Mach Discussion / Re: mach e stop

« on: January 08, 2009, 10:24:21 AM »

hood
that fixed it!!  thanks for everyones help [especially yours]. greg

5

General Mach Discussion / Re: mach e stop

« on: January 07, 2009, 08:41:44 PM »

thanks hood
i can not try it for aprox 12-14 hours then i will let you know. thanks greg

6

General Mach Discussion / Re: mach e stop

« on: January 07, 2009, 06:35:54 PM »

here is the xml. any & all help is appreciated. thanks greg

7

General Mach Discussion / Re: mach e stop

« on: January 07, 2009, 05:09:12 PM »

overloaded
if you can not turn it off how do you use mach if you are new & just trying the demo? thanks greg

8

General Mach Discussion / Re: mach e stop

« on: January 07, 2009, 04:29:16 PM »

yes i am. then the window opens saying a limit is tripped or e stop is active. then i go back into ports & pins. if i had turned it off before it is back on again. thanks greg

9

General Mach Discussion / Re: mach e stop

« on: January 07, 2009, 04:17:04 PM »

i assigned pot 1 pin 11 & the reset still flashes with it set both high & low. anyother ideas? thanks greg

10

General Mach Discussion / Re: mach e stop

« on: January 07, 2009, 04:08:59 PM »

in ports & pins i have turned off the limits. i will try assigning a pin # to e stop. i will let you know what happens. thanks greg