Messages

1

General Mach Discussion / Re: Mach-3 font size

« on: January 28, 2008, 12:10:50 PM »

I also have a DSLS 3000. I have no problem with the button font size if my monitor is at at least 1024x768. However... the G-codes are unreadable. Whats strange is that on a PC with an old flat panel the g-codes look fine. Butt on my new Dell laptop regardless of resolution, adaptor scaling, font size, etc the G-codes are allways unreadable. The A-Z codes just to the left on the same screen are always readable.