1
General Mach Discussion / Re: A axis rotary problem, strange stalling issue
« on: June 01, 2015, 07:02:22 PM »
It is 1:1 as it came from the manufacturer. From what I have found out the actual rotary table gear inside is 90:1. They come as kits with a tailstock etc exactly like the tormach units. It is well within the speed range I think, if I slow it down to 50% it still stalls at what seems to be the same points.
On the program there is no separate feed rate for the A rotary axis. I don't know where the a axis feed rate comes from, surely that should be in deg/min. Could this be part of the problem?
On the program there is no separate feed rate for the A rotary axis. I don't know where the a axis feed rate comes from, surely that should be in deg/min. Could this be part of the problem?