Hello Guest it is March 28, 2024, 05:01:39 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - francopuk

Pages: « 1 2 3 4 5 »
31
General Mach Discussion / Italian screen set
« on: October 26, 2006, 04:38:42 PM »
Hi to all, i search one screen set in Italian language,
tank for any help
Franco

32
General Mach Discussion / Re: 4 axis not work
« on: September 24, 2006, 08:58:22 AM »
resolvet problem
forced parallel port in the matherboard at address 03F8 and assigned IRQ11 on the added parallel card
all is OK
Franco

33
General Mach Discussion / Re: 4 axis not work
« on: September 24, 2006, 03:55:00 AM »
hi Brian, i have check the address, these are 0xda00 for lpt1 and oxd600 for the lpt2, the machine work correctly with 4 axis, the problem is:
i have reset the PC, and restart mach3, and the machine not work (all the axis is off)
my OS is win2000 pro
i have mounted double port lpt and disable the native port in the BIOS
existing solution for this problem?
thank
Franco

34
General Mach Discussion / 4 axis not work
« on: September 21, 2006, 03:55:42 AM »
hi to all
i have mounted the secon printer port on my computer and connecting the parallel interface for 4 axis, and setting:
port#2 0x278 enable
in the motor output have setting:
A axis enable, step pin2, dir pin3, step port 2, dir port 2
in the output signal have setting:
enable4, port 2, pin n 1
after click on apply and restart mach3
in the mdi mode insert command G1 A10 F100, but all the motor are off and not work
what is the problem?
thank in advance
Franco

35
Finished Plugins for Download / Re: New Plugin
« on: September 05, 2006, 11:50:48 AM »
Hi,
is it possible to control more than 2 axis with this plugin? I have a single joystick with 6 axis, but the plugin allows settings only for two of them, side and forward.

Thanks!

36
General Mach Discussion / Re: joistik and mach3
« on: August 30, 2006, 12:10:47 PM »
if is possible, send me the configuration of mach3 for gamepad
tank
franco

37
General Mach Discussion / joistik and mach3
« on: August 30, 2006, 09:53:49 AM »
hi to all,
 i have a joystik usb, this work only 2 axis, this is normal?
thank in advance
Franco

38
LazyCam (Beta) / Re: New Lcam with post processor
« on: August 18, 2006, 12:04:37 PM »
all ok
tank
Franco

39
LazyCam (Beta) / Re: New Lcam with post processor
« on: August 18, 2006, 02:17:10 AM »
hi Brian, i have installed lazy cam ver 2.52, i not find the version 2.60
help me please ?
tank you
Franco

40
LazyCam (Beta) / Re: lazy cam
« on: August 15, 2006, 03:45:14 AM »
tank for help, i setting mach3 in mm and resolve the question.
Franco

Pages: « 1 2 3 4 5 »