Messages

11

Works in progress / Re: Well i finally uploaded my 6 axis screen, was 5 axis.......

« on: February 21, 2008, 04:42:02 AM »

Hello Darc,

Your 6 axis screen used to work before , after I installed mach3 again , it did not work.
although UT buttons are in millbitmaps and screenset in mach3 directory.
Do you know the reason
Thank you
Ayhan

12

General Mach Discussion / output on/off

« on: February 08, 2008, 07:26:33 AM »

Hello ,

I am building 5 axes machine.
And need to command to a welding machine , It sould start to weld and stop and start again while axes are running.
what should I write and insert in g-kode lines
"output 1 on" and "output 1 off"  ? Just like this ?

Best regards
Ayhan Caglar