Hello Guest it is March 28, 2024, 03:16:27 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - ayhan

Pages: 1
1
General Mach Discussion / increase the feed (accelerando)
« on: April 16, 2008, 03:08:10 AM »
Hello everyone,

Is there any G code to increase the feed in the same line.?
For example X will go 20mm . will start as F50 while it finish should be reached F100
as accelerando

Thanks
Ayhan 

2
General Mach Discussion / incremental feed
« on: April 15, 2008, 04:21:27 AM »
Hello everyone,

Is there any way to increase the feed in the same line ?
For example: it will start F100 at the end of the distance will be reached F200

Thank you
Ayhan

 

3
General Mach Discussion / M3-M5
« on: April 04, 2008, 03:14:35 AM »
Hello everyone, :)

After M3 or M5 command axes wait nearly 2 seconds, for spindle turn (or off).
How can I change waiting time as 0 (zero) ?

Ayhan

4
General Mach Discussion / cumulative movement
« on: February 24, 2008, 06:52:14 AM »
Hello,

I need to move axis B as cumulative.
My B axis is indepentent (work as weld wire-feeder) , should not come back and in every loop  , should move plus .
like 1+1=2 , 2+1=3 , 3+1=4    ???
What sould I do ?

Thanks
Ayhan

5
Hii, everyone,

1. I used to use 6 axis screen before , after I re-installed mach3 again it did not worked , buttons can not be seen.
Does anyone know the reason.
2. How can I set active plane as X-Z as default ?
3.How can I change the feedrate as default ?

Thank you from now ,
Ayhan

6
General Mach Discussion / output on/off
« on: February 08, 2008, 07:26:33 AM »
Hello ,

I am building 5 axes machine.
And need to command to a welding machine , It sould start to weld and stop and start again while axes are running.
what should I write and insert in g-kode lines
"output 1 on" and "output 1 off"  ? Just like this ?

Best regards
Ayhan Caglar
   

Pages: 1