Messages

11

General Mach Discussion / Re: Newbie

« on: June 25, 2006, 08:06:47 PM »

Hi Brian, So 3 of these drive should serve my purpose, what about a power supply, and will  I require a breakout board of any kind to interface all this stuff.
I have not yet decided whether to go to a timing belt drive or gear rack, but at the end of the day I would like the unit to have a bit of grunt for machining ally
components and composite patterns.

Thanks in advance.

12

General Mach Discussion / Newbie

« on: June 25, 2006, 07:29:10 PM »

Hi all, I had only found this site the other day and the information is awesome.
I am building a 3 axis router x 36inch travel on 35mm bearings and shafts, y 24inch travel on 30mm slides and z 12inch travel on 25mm slides.
I am planning on running 3 nema34 1080 oz bipolar steppers and wanting to use Mach3, can anyone please recommend any drivers and power supply that would
best serve this setup, as I am not too familiar with the hardware setup for this unit.



Cheers Pumpa.