Messages

11

General Mach Discussion / Re: Mach3 Screens Text and numbers do not fit screen layout/entryboxes properly

« on: January 22, 2008, 10:49:12 AM »

Two attachments as requested (In doc files).

Thanks again for your help

12

General Mach Discussion / Re: Mach3 Screens Text and numbers do not fit screen layout/entryboxes properly

« on: January 22, 2008, 04:40:01 AM »

Results:
17" LCD Monitor.
Auto sizing  with screen resolution set to 1280x960  (a multiple of 1024 x768) helps quite a bit with, but display of data is still not properly centered in the boxes (too low with  bottom of figures truncated). With LCD monitor set to 1024x 768 (A  bit out of the normal useful range these days), the data is not truncated., but actually slightly overlaps the bottom of the boxes.
****************
Using a 14", 1995 vintage, CRT monitor at the limit of its resolution (1024 x768) the display is correctly presented at all times. This is presumably more like the environment for which Mach3 was  designed.
****************
Thanks for your help

13

General Mach Discussion / Mach3 Screens Text and numbers do not fit screen layout/entryboxes properly

« on: January 20, 2008, 01:07:55 PM »

I normally use a hi res screen set to  1280 x1024 and experience no problems with any software except with Mach3. I have tried altering the configuration settings inside Mach3 but achieved no improvement in the appearance.  I also tried changing the screen to 1280 x 960 to maintain the same aspect ratio as 1024x768 with no effect. I am still experiencing truncated data displays. Does anyone know how to improve the presentation?