Hello Guest it is April 28, 2024, 01:49:49 AM
Profile Guest

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - ataxy

Pages: « 1 2 3 4 »
21
General Mach Discussion / Re: long pause on tool change in simulation
« on: November 27, 2008, 12:32:53 PM »
nope still the same with the lockdown i get around 1hr wait period per tool change

22
General Mach Discussion / Re: long pause on tool change in simulation
« on: November 27, 2008, 12:13:17 PM »
ok ill try the lock down in any case here is the xml i am using

23
General Mach Discussion / Re: long pause on tool change in simulation
« on: November 27, 2008, 11:32:00 AM »
version 3.041, and no to both, i use it on a syilX4+

24
General Mach Discussion / long pause on tool change in simulation
« on: November 27, 2008, 09:58:03 AM »
OK i have a little problem with the simulation mode i don't know if this is normal but is there a way to change the wait period on tool change in simulation when mach3 hits a line with a tool change it can wait sometime for an hour of simulated time before going on with the simulation. so a part that should have taken 1hr will take 4hr in simulation mode

25
Works in progress / Re: Fanuc-O ld school
« on: October 03, 2008, 01:39:57 PM »
wow this is an impressive screen would make, at least for me, the switch from the machine i am used to easyer

26
Works in progress / Re: Led City
« on: March 09, 2008, 11:11:49 AM »
wow! that screen is wow, simply wow, simple ans efficient!

27
Newfangled Solutions Mach3 Wizards / Re: V 2.77 ready for test
« on: February 14, 2008, 07:19:30 AM »
same nothing happens

28
Newfangled Solutions Mach3 Wizards / Re: V 2.77 ready for test
« on: February 13, 2008, 02:23:00 PM »
yep when i click nothing happen i am trying it on the latest dev release

29
Newfangled Solutions Mach3 Wizards / Re: V 2.77 ready for test
« on: February 13, 2008, 01:45:56 PM »
cant click on material selection, wasnt there more option before in the main screen

30
Third party software and hardware support forums. / Re: problem getting mach3 to make my motor turn
« on: January 17, 2008, 11:50:54 PM »
to see a follow up of this problem check the mach yahoo group

Pages: « 1 2 3 4 »