1
Brains Development / Re: Howto send DRO Axis information?
« on: January 09, 2008, 10:45:57 AM »
I fear you do not understand what I mean.
The DROs content is a floting point value , and you need more than one 16bit register to represent this value. But Mach3 sends only one 16bit register.
Forget about HEX, ASCII, Real or Binary - this is the step that folows after Mach3 has transmit the value to the PLC. I can not handle with a value that will not completely transmited.
Thanks, G.
The DROs content is a floting point value , and you need more than one 16bit register to represent this value. But Mach3 sends only one 16bit register.
Forget about HEX, ASCII, Real or Binary - this is the step that folows after Mach3 has transmit the value to the PLC. I can not handle with a value that will not completely transmited.
Thanks, G.