191
General Mach Discussion / Re: Mach3 using Galil servo card
« on: March 19, 2008, 12:16:33 PM »
Just want to add my input here. I am also using a Galil 1700 board. I have unchecked both boxes under "motor options" in the Galil plugin. My DRO's now display the actual axis position as returned by the encoders. If I power down the axis and move the table, the DRO's display the actual movement of the unpowered table. Might be worth trying on Your system. Are any of You using a pendant for edge locating? If so which one. I was looking at Peter Homanns pendant, but am not sure about it working with Galil controllers. Any input?
Thanks,
Kenny
Thanks,
Kenny