Hello Guest it is March 28, 2024, 09:22:42 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - bobbyr70

Pages: 1
1
General Mach Discussion / Homing Slaved axis
« on: January 03, 2010, 10:25:57 PM »
Ok, most everything works on my machine, I managed to get the home function to work after reading a few posts. (Debounce interval) I have a dual X axis gantry. I set up the B as a slave to the X axis. I reference home in hopes of squaring up the gantry after start up, everything goes home and backs off the switches like it is supposed to but the slaved axis just follows the X command. I even tried to reference B but it acted like the others did when the debounce interval was Zero. I set the debounce at 1000. Is there something else I need to do to get the B side of the gantry to home?

Pages: 1