Topics

31

Newfangled Solutions Mach3 Wizards / Wizard suggestions -

« on: June 14, 2006, 11:49:14 AM »

Great work on the wizards.
Just finished watching the video and have a couple of suggestions.

On "rectangular Pocket"  you have "finish amount"  and "finish Feed Rate"  Why not add them to circular pocket wizard as well.
in the video that was a whole set of extra steps.  IF there is a tool change required it would still work as in the video.

On Circular Groove you call it "pitch" on other its called ramp angle.  Are they the same should they be called the same.

Sorry Just stupid things I noticed that caught me on the first look. 

32

LazyCam (Beta) / trouble with 2.53

« on: June 13, 2006, 03:26:50 PM »

I've loaded up mach3 1.90.05 (beta) with the new lazy cam 2.53.

Having trouble getting it to generate gcode files.  Often when i try to generate G-codes i get the microsoft serious error screen that kick me out of LC and shuts it down. I cannot prove it yet but it ususally follows trying to set the depth on the right hand side. 

Left tool panel for set depth always causes the problem.

Other times when i go back to Mach3 the file and Gcodes do not exist. or show up on screen.

Any ideas

33

LazyCam (Beta) / Where di i get latest release

« on: June 10, 2006, 08:25:12 AM »

New to forum.  Like the idea of LC. Looking for latest release of LC.
I have the version with Mach3 1.9 and the version with Mach4 is improved but not running with Mach3.
lazy about switching back and forth