11
General Mach Discussion / So Close to it working!
« on: January 03, 2008, 11:14:06 PM »
Hi All,
I am having a tough time getting my Rockcliff router to work. I running Gecko G203V drives and Keling motors. When I home my maching axis, the x-axis will continue moving even though the home switch got triggered, it did not move off the switch. The error message read "Softlimit max< min" this just started to happen. The other thing that was happening when try to home was that the y-axis is that it would move but never even come close to the switch and then stop and begin homing the other axis. On the z-axis, it was moving in the oppisite direction of the switch. I am going to post my settings, can some one tell me what is wrong.
Thanks,
skipper
I am having a tough time getting my Rockcliff router to work. I running Gecko G203V drives and Keling motors. When I home my maching axis, the x-axis will continue moving even though the home switch got triggered, it did not move off the switch. The error message read "Softlimit max< min" this just started to happen. The other thing that was happening when try to home was that the y-axis is that it would move but never even come close to the switch and then stop and begin homing the other axis. On the z-axis, it was moving in the oppisite direction of the switch. I am going to post my settings, can some one tell me what is wrong.
Thanks,
skipper