Hello Guest it is March 28, 2024, 10:19:43 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Rose

Pages: 1
1
I am trying to cut a simple square out of my stock.  My stock is .75" thick.  My G Code sets the Z to plunge and cut to Z-0.75.  The Axis begins to plunge about half way, then appears to do a small bounce upward, then cuts leaving a cut depth of about -0.25.  Once it finishes the square cut it begins to cut air on any other geometry that is after the Z-0.75 cut.

Can anyone help with this?

Pages: 1