41
General Mach Discussion / Re: tuning steppers in mach 3
« on: November 20, 2006, 05:35:56 PM »
right now im running 3 of them at 24v 4.5 amp power supply
Operation
Holding torque-Nm (oz/in) +/- 10% 262
Rated voltage 3.2
Rated current per phase (amps DC) 2.8
Resistance (Ohms) +/- 10% 1.13
Induction (mH) +/- 20% typical 3.6
Motor length (mm) 76
Rotor inertia (g-cm^2) 480
Weight (kg) 0.92
Operation
Holding torque-Nm (oz/in) +/- 10% 262
Rated voltage 3.2
Rated current per phase (amps DC) 2.8
Resistance (Ohms) +/- 10% 1.13
Induction (mH) +/- 20% typical 3.6
Motor length (mm) 76
Rotor inertia (g-cm^2) 480
Weight (kg) 0.92