Messages

1

General Mach Discussion / Re: SURFACE WIZARD

« on: June 06, 2006, 06:12:58 PM »

Thanks for all the info guys. I have finally got it 

As an aside : Let me ask about the type of cutter shown in the wizard. I have a cheap (Asian) one that came with my Asian mill.
It has three inserts and I notice that they are not all at the same depth. Is this normal (each insert taking a progressively deeper bite) or are they supposed to be all at the same depth?

2

General Mach Discussion / Re: SURFACE WIZARD

« on: June 04, 2006, 07:44:07 PM »

Thanks for all your responses guys. Still not getting the results I,m looking for.
See screen shot.

3

General Mach Discussion / SURFACE WIZARD

« on: June 03, 2006, 01:35:42 PM »

I'm trying to use the Surface with tool down in x Wizard and not having much luck.

I'd like to rough cut to a certain z height and then slow feed rate down for finish cut last .002.

Is there info somewere on this wizard?