Messages

11

Works in progress / Re: CorelDraw engrave

« on: December 20, 2007, 11:26:37 PM »

Wow this looks very nice.
I just finished with a new core for converting plt files.( Its 5 in the morning here)
Its much more stable and it can also handle older Corel versions now.

Can you give me a good beginner guide where i can learn Flash programming?
What editor can i use for building Flash screens for Mach3?
Im new to this and i must look into it first before i can give you an answer.

12

Works in progress / Re: CorelDraw engrave

« on: December 18, 2007, 04:07:14 PM »

Some pictures:
All designed with coreldraw12 and milled with this Mach3 screen.

13

Works in progress / Re: CorelDraw engrave

« on: December 18, 2007, 10:50:24 AM »

Hi
This is a little example of a gearbox made from wood.

width = 65 mm /  Height = 64 mm / Cutter diameter = 4 mm.
You must tweak around with the XY factor for the right dimensions.

Safeheight around 5 mm
Enter the following pen settings:

Pen                 1             2           3           4
Feedrate        200         200       200        200
Depth             -5.5        -10.5     -10.5    -17.5
Start depth     0             -5.5      0            -10.5
Depth steps    -1           -1          -1          -1
Dwell time     0.5         0.5        0.5         0.5
Smart fill        2            2           2            2
Smart drill      100        100       100        100
Plunge speed  100        100       100        100
(Feedrate and Plunge speed Depends on yore hardware configuration)
I hope this works.

14

Works in progress / CorelDraw engrave

« on: December 16, 2007, 02:32:00 AM »

Hi
I'm using Corel Draw to make designs and wanted to engrave plt ( HPGL ) files with Mach3.
This screen can import HPGL files generated with Corel Draw and converts it to Gcode.
With this screen you can set the following parameters for 8 different colors:
-Feedrate speed
-Depth
-Start depth
-Depth steps
-Dwell time
-Smart fill
-Smart drill
-Plunge speed
-Peck drill
-Tool change
-Drill option
-Enable / Disable Colors

It’s very easy now to make a design in Corel Draw and engrave with Mach3.

Greetings
roger