Hello Guest it is March 29, 2024, 03:23:04 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Jim Neifert

Pages: « 1 2 3 4 5 6 »
41
General Mach Discussion / Re: What Have I done?
« on: November 05, 2006, 12:30:10 PM »
that is the problem,,the picture is taken after I double click. I can right click and hold drag the table outline down into full view but when I double click it goes right back up to where the picture shows it

42
General Mach Discussion / Re: What Have I done?
« on: November 05, 2006, 12:24:02 PM »
ok hope this shows you what I mean

Jim

43
General Mach Discussion / Re: What Have I done?
« on: November 05, 2006, 12:05:53 PM »
could if you tell me how, I would guess use Prt Scr, just not sure where it puts the file, never used it before

44
General Mach Discussion / Re: What Have I done?
« on: November 05, 2006, 12:00:42 PM »
ok if I double click it goes from the Isometric View back to table display, which again places the coloured arrows, so far down on the screen I can not see but only part of my table outline

mayby this is just a normal thing?

45
General Mach Discussion / Re: What Have I done?
« on: November 05, 2006, 11:56:17 AM »
yes sir it is.


46
General Mach Discussion / Re: What Have I done?
« on: November 05, 2006, 11:47:03 AM »
Ok thanks, that I have figured out, but why is the table outline so far away from the x y and z arrow indicator?

Jim

47
General Mach Discussion / Re: What Have I done?
« on: November 05, 2006, 11:26:09 AM »
Sir Chip
Well as long as I am showing my stupidity, why in my screens does the x y and z arrow show up below my table outline? In the "program run" screen with table display on, the table outline is almost at the top and the coloured arrows is almost at the bottom.

Jim

48
General Mach Discussion / Re: What Have I done?
« on: November 05, 2006, 09:39:37 AM »
Thanks Chip, that took care of it.

again thanks Chip and Chaoticone for the help.

Jim

49
General Mach Discussion / Re: What Have I done?
« on: November 05, 2006, 09:21:11 AM »
Its flashing all the time with this warning. I am just not sure what I changed, was just setting up my mill when it started. I have a sherline with Xylotex board, no switches and in the Diagnostics page there are no lights.

I printed off the Mach3 Mill Manual but can't find anything on it.

Jim


50
General Mach Discussion / What Have I done?
« on: November 05, 2006, 08:44:59 AM »
I am getting an Abnormal flashing button with a comment about "Axis are not refed to normal condition". Somehow I started this and now can't figure out how to correct the problem. OK, I am not sure what it means or what I did to cause it.

Can anyone help?

Jim

Pages: « 1 2 3 4 5 6 »