91
General Mach Discussion / single block
« on: November 10, 2005, 01:43:03 PM »
Hi,
I have a problem with single block not working or doing wierd stuff. Last nite I clicked single block, let it come down near part & looked away at screen for a bit. It started cutting when I was not ready for it and kept on going, block after block. I clicked single block off then on and it stopped at the end of the next block as it should. Then later I clicked it near the end of a toolpath in preparation to check the next move and it took off, at least AWAY from the part. It did this during an arc out of a contour. I restarted and it worked as it should. I had this problem a lot with Mach 2 and now it's doing it with Mach 3(v 1.83.012 I think).
Any ideas?
Thanks
Mark
I have a problem with single block not working or doing wierd stuff. Last nite I clicked single block, let it come down near part & looked away at screen for a bit. It started cutting when I was not ready for it and kept on going, block after block. I clicked single block off then on and it stopped at the end of the next block as it should. Then later I clicked it near the end of a toolpath in preparation to check the next move and it took off, at least AWAY from the part. It did this during an arc out of a contour. I restarted and it worked as it should. I had this problem a lot with Mach 2 and now it's doing it with Mach 3(v 1.83.012 I think).
Any ideas?
Thanks
Mark