Messages

1

General Mach Discussion / Re: Mach 3 with tb6560 4 axis (little blue) board controller

« on: February 01, 2012, 06:40:19 AM »

Thanks Rich

I must admit I have not played with Mach for a couple of years and the memory fades.

Clive

2

General Mach Discussion / Re: Mach 3 with tb6560 4 axis (little blue) board controller

« on: January 30, 2012, 07:01:13 AM »

Rich
I started by asking for the details from the seller, but like a lot of the people they are just box shifters and they dont have any information or cant be bothered to get it.
I have trawled around the other sellers and they dont appear to have any information either.

As this is going to have a 4th axis are there any keyboard commands for the A axis, I know X Y and Z.



Regards

Clive

3

General Mach Discussion / Re: Mach 3 with tb6560 4 axis (little blue) board controller

« on: January 30, 2012, 05:28:47 AM »

Thanks for the reply
Here is a link http://www.ebay.co.uk/itm/370556718754?ssPageName=STRK:MEWNX:IT&_trksid=p3984.m1497.l2649

4

General Mach Discussion / Mach 3 with tb6560 4 axis (little blue) board controller

« on: January 29, 2012, 11:32:26 AM »

Hi
I have just got my tb6560 4 axis controller working with Mach 3 despite the instructions.
With it I bought a little blue hand controller that plugs in and is meant to act as a pendant, this does not work.
Two questions really the first, are there any settings in Mach 3 to turn it on?
Also it has a miniature USB connector on it, does this need to be powered (there is 5 volts on the board).
I can find no information anywhere about this controller not even a pin out.

Regards

Clive

5

GearoticMotion Preliminary testing / Re: Gearotica testing

« on: July 30, 2010, 01:59:51 PM »

I also found the text very difficult to read

6

GearoticMotion Preliminary testing / Re: Gearotica testing

« on: July 29, 2010, 02:24:20 PM »

Had mostly the same problems as Rich no project button slider didnt work in involute.
This was with a socket 939 mboard with Amd 4200 dual and a Fire XL graphics card.

7

General Mach Discussion / Re: Turn Eccentric Wizard

« on: March 31, 2010, 03:31:08 PM »

Having thought about it for a bit, that ony gives you an offset arc not an eccentric circle!!

8

General Mach Discussion / Re: Turn Eccentric Wizard

« on: March 31, 2010, 03:26:26 PM »

Thats a very good idea Graham, but I was only being lazy.
I seem to speed ages setting up 4 jaw chucks

Clive

9

General Mach Discussion / Re: Turn Eccentric Wizard

« on: March 31, 2010, 02:46:19 PM »

I did too.

10

General Mach Discussion / Re: Turn Eccentric Wizard

« on: March 31, 2010, 12:13:16 PM »

Very Good point I will definately stick to 4 jaw chuck

Clive